New PU 10R available for shipment

The rolling of the PU 8R, the first sheet pile of the new PU-R range, took place in March 2008, and the first sheet piles have already been supplied. Next on line was the heavier PU 10R, and we are proud to announce that this section is now also available. The sheet piles rolled in this first industrial trial in May 2008 fulfilled all the criteria of the European standard.

The PU 10R range is available in all steel grades of the EN 10248, from S 240 GP to S 430 GP. This exceeds the initial target, an S 355 GP steel grade.
They can be delivered in lengths up to 24.0 m, and can be paired and crimped on request.

Based on our original planning the next section of the new PU-R range will be the PU 14R available in short notice.

As for the PU 6R and PU 7R, please contact our Technical Department.

From now on, the following U-type sections of the lower range (W_x up to 1300 cm³/m) are available:

^* W_x = elastic section modulus of the sheet pile wall.